*** Made is USA ***

Steel Locking Bars for Truck Topper Lids

Overall length (end to end) = 98 inches

(Can be cut to any length for you application)

MORE Items listed in our Store

You are bidding on a 1ea Universal fit ' 98 inch (end to end) Lock bar / Deadbolt for T and L handle locks (these are used with our T ' handle locks)

Steel Locking Bars are used on many truck caps which have a single handle lock in the center of the door. The cam action design allows the rods to retract or extend as needed. 4ea Rod guides are included. Repair your truck cap door today!

The lock bars include a center rotating cam attached to the rods (with locking set screw) that fits over the handle shaft (again the rods can be cut to any desired length) we have also included 4ea each rod guides (normally you just use 2 - keep the others for spares if not needed) for mounting the lock bars (we also sell the rod guides separate if need be) 

NOTE: when cutting to length be sure the handle is in the lock position as not to cut the rods to short!!!

We have in stock several types of locking t-handles (blind mount, front mount) as well as Dead bolts, Cam locks, Nylon rod guides and flush mount tonneau cover keyed alike lock sets as well as most all topper, rear and side door gas springs, struts, shocks (check out our store!)

TIP: If you have a DIY project that you would like to have the added security of locking the Lid, Cover, Cap, Door, Gate or just about any opening our self contained handles with key locks might just be what you are looking for! EASY install for most any project!

The shipping and handling is FAST (in most cases 'we ship the same day as payment is made) at set cost of $19.95 (postage + partial packing cost) for the first and 4.25 for each additional (multiple items may be shipped USPS or FedEx depending weight and destination)   We ship to the USA only